waterproofing
paint suppliers
SatinTex



Satintex has been formulated using specialised raw materials to achieve a tough coating with a smooth textured finish. Satintex has been designed to cover plaster imperfections, with excellent adhesion, flexibility, water and alkali resistance. Satintex can be used as a first coat on good quality, cured plaster. Satintex can be tinted in a variety of colours and can be over coated with a final coat if required.


FEATURES

-- Satintex is non-yellowing, odourless, non-toxic and enviro-friendly. - For use on interior or exterior walls. - Available in a wide range of colours. - Can be applied directly to good quality, cured plaster as a primer. - Excellent flexibility - Gives a smooth texture with high film build.


SURFACE PREPARATION AND APPLICATION


New Plaster
  1. Remove all loose friable material.
  2. Satintex can be applied directly to good quality, cured plaster.
  3. If the plaster is very friable then apply 1 coat of Paintcor’s Acryseal Acrylic Sealer diluted 1:1 with water to all new plaster. Allow to dry for 30 min @ 25 degrees C.
  4. Apply 1 or 2 coats of Paintcor’s Satintex by brush or roller
Previously Painted Plaster
  1. Check adhesion of existing paint. (Cross hatch method) Using a stanley knife, cut through the paint surface to the substrate vertically and horizontally approximately 3mm apart, creating little squares. If the edges of the squares curl up, and the square can easily be removed, this means the adhesion of the old paint system is failing.
If adhesion is poor:
  1. Remove all old paint back to existing plaster.
  2. If surface is powdery (chalking), wash to remove all powder. Allow to dry.
  3. Apply 1 coat of Paintcor’s AcrySeal Acrylic Sealer diluted 1:1 with water to all exposed plaster and washed chalking surfaces. Allow to dry.
  4. Apply 1 or 2 coats of Paintcor’s Satintex by brush or roller
If adhesion is good:
  1. Wash walls to remove all dirt and dust. Allow to dry.
  2. Apply Satintex as per no 4 above

Applying Satintex requires professional painters with knowledge of applying high film build textured finishes. Incorrectly applied Satintex may result in a streaky finish. Please contact our Technical Department for training on application of textured coatings.

Cleaning Equipment

Clean all equipment immediately after use with water.

PDF

 
SatinTex

- Safety Data Sheet PDF



 
SatinTex

- MSDS PDF



 
SatinTex

- TS PDF



OTHER PRODUCTS

December 6, 2015
abrasives

Econocryl

Econocryl Contractor’s Acrylic is an economic product which allows both hiding power and maintenance at a low cost without leaving traces of powder. Econocryl is perfect […]
December 6, 2015
unisub

Elegance matt

Elegance Matt is a high-quality, environmentally-friendly exterior wall coating, designed and formulated using quality raw materials to combat South Africa’s extreme climatic conditions.
September 12, 2019
waterproofing

ENVIROPRIME

Elegance Silk is a high-quality, environmentally-friendly exterior wall coating, designed and formulated using quality raw materials to combat South Africa’s extreme climatic conditions.
Contact Us